How often does the new sand making machine be maintained? What is the maintenance required? What is the service life of the sand making machine?
Any sand and gravel equipment needs to be treated well, sand making machines and sand blowers are no exception. The life of the sand making machine is closely related to daily maintenance. Regular and necessary maintenance of the sand making machine can effectively extend the life of the sand making machine and avoid it. The occurrence of dangerous accidents. Here is an introduction to our company's star product-the new sand making machine and its maintenance methods for our customers!
In the artificial sand making industry, it is necessary to produce ideal machine-made sand products and concrete aggregates; in the field of stone shaping, it is necessary to obtain high-quality, good-grained crushed stone products; 5X series of new sand making machines and DVSI sand making machines are good It is an effective choice. This machine is designed to provide high-quality sand and gravel aggregates for highways, high-speed railways, high-rise buildings, municipal administration, hydropower dam construction, and concrete mixing stations. It is an equipment in the field of artificial sand making and stone shaping.
First of all, before starting the sand making machine, check whether the vortex chamber observation door is closed tightly to prevent materials from rushing out of the vortex chamber observation door, which may cause danger. Check the direction of rotation of the impeller, looking from the direction of the material inlet. The impeller should rotate counterclockwise, otherwise the motor wiring should be adjusted. The starting sequence of the sand making machine equipment and the conveying equipment is: discharge to the sand making machine and then to feeding; the sand making machine must be started with no load and can only be fed after the sand making machine is running normally. The stopping sequence is opposite to the starting sequence.
Secondly, feed particles are strictly in accordance with the regulations. Materials larger than the regulations are prohibited from entering the sand making machine. Otherwise, it will cause imbalance of the impeller and excessive wear of the impeller, and even block the impeller channel and the central feeding pipe, making the sand making equipment unable to Normally, if the material is found to be too large, it should be eliminated in time.
Thirdly, when the discharging equipment is stopped, the feeding should be stopped in time, otherwise, the impeller will be crushed and the motor will be burnt. Strive for continuous and even feeding. During the operation of the sand making machine equipment, there should be no severe vibration and abnormal noise, otherwise it should be shut down for inspection. In order to ensure the energy saving and high efficiency of the sand making machine equipment, the tightening force of the rotating triangle tape of the sand making machine should be adjusted appropriately to ensure the uniform force of the triangle tape. When driven by dual motors, the triangle tapes on both sides should be grouped The group length is as consistent as possible. Regularly shut down and open the observation door to observe the internal wear of the sand making machine, the wear level of the center feed pipe, cone cap, impeller, upper and lower channel liners, circumferential guard plates, and wear blocks. After wear, they should be replaced or repaired in time. The block should be replaced in time to ensure that the weight of the wear block is the same. It is strictly forbidden to open the observation door to observe the internal situation during the crusher. So as to avoid danger. If the impeller body is found to be worn, replace it in time and seek repair from the manufacturer.
The machine has less friction between materials and wear parts, which directly reduces the use cost of the equipment. Compared with the traditional equipment under the same power, the output is increased by 30%, and the mechanical performance is relatively stable.
The product is cubic, with good grain shape, reasonable gradation, and adjustable fineness modulus, which is especially suitable for artificial sand making and stone shaping. In addition, the bearings of this machine adopt high-precision international brands to ensure a low failure rate of the system, and are equipped with original German thin oil lubrication stations to completely solve problems such as bearing heating.
If you are interested in investing in machine-made sand production, you can leave us a message below, consult our website customer service staff, tell us the material you want to process and the output size, we will recommend suitable equipment for you and develop a detailed production line configuration plan , So that you can buy cheap and good-quality equipment without spending any more money